The Pick-Up Truck Thread
Re: Buriram Trip Report with Photos
Most if not all pick up's have drain holes where the floor meets the front wall of the bed. Hopefully any bed liner that's installed has holes as well, or places where holes should be cut out.
At the other end, tailgates are not watertight and water will drain naturally from there while driving. Again, if a bed liner is put in it could hinder rear drainage if it fills up that hinged tailgate gap.
With the Toyota Tiger PU I had years ago the bed liner installation people knew what to do and made sure the appropriate holes/gaps were there.
At the other end, tailgates are not watertight and water will drain naturally from there while driving. Again, if a bed liner is put in it could hinder rear drainage if it fills up that hinged tailgate gap.
With the Toyota Tiger PU I had years ago the bed liner installation people knew what to do and made sure the appropriate holes/gaps were there.
Governments are instituted among Men, deriving their just powers from the consent of the governed. Source
Re: The Pick-Up Truck Thread
My liner was dealer fitted, as most are. There are certainly no drainage holes in my liner. As for draining through the tailgate - yes, if I brake suddenly going uphill (which is what I did in the Buriram trip report), but it does seem to be a rather good fit.
I've always considered it a design feature .
I've always considered it a design feature .
Championship Plymouth Argyle 1 - 0 Hull City
Points 51; Position 21
Consolidated - Championship Next Season
Points 51; Position 21
Consolidated - Championship Next Season
Re: The Pick-Up Truck Thread
In days gone by (the 90's) you had to go to someone like Carryboy to get your bed liners. I don't recall Toyota ever offering it back then as an accessory.
Get some young flexible lad to go under your Ford and check to see if holes at the front of the bed where it meets the wall.
Get some young flexible lad to go under your Ford and check to see if holes at the front of the bed where it meets the wall.
Governments are instituted among Men, deriving their just powers from the consent of the governed. Source
Re: The Pick-Up Truck Thread
That's a 2019 Ford Ranger. It appears to be a punch out in the liner a bit raised from the bed surface. It leads to somewhere so there must be a hole or gap in the steel bed floor somewhere below that punch out.
Governments are instituted among Men, deriving their just powers from the consent of the governed. Source
Re: The Pick-Up Truck Thread
We've got an older Toyota Vigo and a new Isuzu Dmax and I don't recall either of them having drainage in the bed liners, any water just goes out of the tailgate.
If I don't take care and park with the back end out of the carport, you can end up with a cm or so of water in the back.
To be honest, I've rarely put anything delicate in the back so never gave it much thought but those fitted covers make sense if you're using it for luggage.
If I don't take care and park with the back end out of the carport, you can end up with a cm or so of water in the back.
To be honest, I've rarely put anything delicate in the back so never gave it much thought but those fitted covers make sense if you're using it for luggage.
-
- Addict
- Posts: 5389
- Joined: Mon Mar 03, 2014 11:58 am
Re: The Pick-Up Truck Thread
Can you drill a couple of holes in the bed of the truck?
-
- Addict
- Posts: 5389
- Joined: Mon Mar 03, 2014 11:58 am
Re: The Pick-Up Truck Thread
Or, are canvas or fiberglass bed covers available here?handdrummer wrote: ↑Wed Nov 30, 2022 5:49 pm Can you drill a couple of holes in the bed of the truck?
Re: The Pick-Up Truck Thread
Yes, you can get lockable fibreglass covers so you can basically have a large boot/trunk space.handdrummer wrote: ↑Wed Nov 30, 2022 10:02 pmOr, are canvas or fiberglass bed covers available here?handdrummer wrote: ↑Wed Nov 30, 2022 5:49 pm Can you drill a couple of holes in the bed of the truck?
Re: The Pick-Up Truck Thread
I don't know about 2019, but when my car was new, 10 years ago, Ford did not brand their add ons. I actually felt seen off when none of my add ons had Ford Branding, but I soon realised any spares with Ford Branding were knock-offs. Of course, that may have changed with time.
Looking at Pete's photo, even if you did punch those bits out, you will still hold a few cms of water.
Here is a photo of my Ford fitted 2012 liner.
Championship Plymouth Argyle 1 - 0 Hull City
Points 51; Position 21
Consolidated - Championship Next Season
Points 51; Position 21
Consolidated - Championship Next Season
Re: The Pick-Up Truck Thread
Had a liner fitted from new when I bought a Navarra about six years ago. No drainage holes and where we lived the car was parked on a slight slope. If I left it parked downslope when it rained I had to make sure that nobody was following me for the first upslope. Fortunately we were in a small Moobaan and the roads were quiet with an upslope on the way out.
I would have been reluctant to put any drain holes in it as the gap between the liner and original bed would have become a rust trap. I do wonder what lies beneath the liners of many older trucks and expansion and contraction plus carrying loads will likely wear through the paint underneath. Has anyone removed a liner from an older truck and found out.
I would have been reluctant to put any drain holes in it as the gap between the liner and original bed would have become a rust trap. I do wonder what lies beneath the liners of many older trucks and expansion and contraction plus carrying loads will likely wear through the paint underneath. Has anyone removed a liner from an older truck and found out.
- Dannie Boy
- Hero
- Posts: 12412
- Joined: Wed Jan 13, 2010 8:12 pm
- Location: Closer to Cha Am than Hua Hin
Re: The Pick-Up Truck Thread
I’m sure your suspicions of what to expect are well founded!!Gregjam wrote: ↑Thu Dec 01, 2022 2:46 pm Had a liner fitted from new when I bought a Navarra about six years ago. No drainage holes and where we lived the car was parked on a slight slope. If I left it parked downslope when it rained I had to make sure that nobody was following me for the first upslope. Fortunately we were in a small Moobaan and the roads were quiet with an upslope on the way out.
I would have been reluctant to put any drain holes in it as the gap between the liner and original bed would have become a rust trap. I do wonder what lies beneath the liners of many older trucks and expansion and contraction plus carrying loads will likely wear through the paint underneath. Has anyone removed a liner from an older truck and found out.
Re: The Pick-Up Truck Thread
Any manufacturer existing hole in the front of the liner, and any made by an owner, are not meant to be drilled through the metal truck bed. There should be a small gap at the front of the truck bed that allows for drainage.
Any front liner hole should match up with that gap.
I don't have a pick-up any longer so I can't check how they're manufacturing this gap, if any, these days.
Any front liner hole should match up with that gap.
I don't have a pick-up any longer so I can't check how they're manufacturing this gap, if any, these days.
Governments are instituted among Men, deriving their just powers from the consent of the governed. Source
Re: The Pick-Up Truck Thread
Here is Ford Rangers great, great, great, great, grandfather.
It is a 1954 Australian Ford Mainline. Called a “ute” in Oz speak, it was unique to Australia. (in the US a Mainline was a sedan car) It had a chassis from the same year Ford convertible car, and the same flathead side valve V8 engine. (and a front seat the size of a double bed!)
But the point here is that it came with a canvas cover for the tub. There was a “gutter” behind the rear window, and the cover had a molded round matching section that fitted into it. There were 2 wooden “bows” that fitted into sockets to make a tent like cover. Around the outsides and rear of the tub were push on clips to retain the cover in place.
Absolutely water tight, and I remember as a kid going on a road trip with my father, and we slept in the tub under the cover.
And yes, that is my first Land Rover!
It is a 1954 Australian Ford Mainline. Called a “ute” in Oz speak, it was unique to Australia. (in the US a Mainline was a sedan car) It had a chassis from the same year Ford convertible car, and the same flathead side valve V8 engine. (and a front seat the size of a double bed!)
But the point here is that it came with a canvas cover for the tub. There was a “gutter” behind the rear window, and the cover had a molded round matching section that fitted into it. There were 2 wooden “bows” that fitted into sockets to make a tent like cover. Around the outsides and rear of the tub were push on clips to retain the cover in place.
Absolutely water tight, and I remember as a kid going on a road trip with my father, and we slept in the tub under the cover.
And yes, that is my first Land Rover!
May you be in heaven half an hour before the devil know`s you`re dead!
Re: The Pick-Up Truck Thread
Better beast of burden - Mitsubishi's sixth-gen Triton
https://www.bangkokpost.com/business/mo ... gen-triton. (Photos)
You'll fit in this one BB. I sat in one the other day and the front compartment is as big or bigger than any Ford Ranger I've been in.
If you wander by a showroom, take a look.
https://www.bangkokpost.com/business/mo ... gen-triton. (Photos)
You'll fit in this one BB. I sat in one the other day and the front compartment is as big or bigger than any Ford Ranger I've been in.
If you wander by a showroom, take a look.
Governments are instituted among Men, deriving their just powers from the consent of the governed. Source
- Dannie Boy
- Hero
- Posts: 12412
- Joined: Wed Jan 13, 2010 8:12 pm
- Location: Closer to Cha Am than Hua Hin
Re: The Pick-Up Truck Thread
After 11 years he must be due an update!!PeteC wrote:Better beast of burden - Mitsubishi's sixth-gen Triton
https://www.bangkokpost.com/business/mo ... gen-triton. (Photos)
You'll fit in this one BB. I sat in one the other day and the front compartment is as big or bigger than any Ford Ranger I've been in.
If you wander by a showroom, take a look.
Sent from my iPhone using Tapatalk